The forklift has changed from the previous fuel to the current electric forklift, which brings many conveniences to our lives. Some drivers find that after long-term driving, electric forklifts will make noise after a period of time. How is the noise of the forklift generated? What precautions should be taken to operate the clutch to avoid noise? The following is a detailed introduction for everyone.
a. Reasons for noise problems of electric forklifts
1. Check whether the conflict between the guide wheel, the roller and the mast is too large. Whether the cooperation gap between the fork and the fork frame crossbeam is too large, these factors will cause the electric forklift to produce greater noise during use.
2. The gap between the chain and the pin of the chain pin is too large, or the gap between the upper and lower staples of the fork and the crossbeam of the fork frame is too large.
3. Loose fasteners, severe wear of the guide wheels and rollers of the car body, resulting in a large gap.
b. Matters needing attention
1. When the electric forklift is not using the clutch, do not put your feet on the clutch pedal to avoid the semi-linkage phenomenon of the clutch, affect the power transmission, and aggravate the wear of clutch plates, clutch bearings and other mechanical parts.
2. No matter whether it is high-end downshifting or low-range upshifting during driving, it is forbidden to shift the clutch without collapsing.
3. Frequently check and maintain the clearance between the separation lever and the separation bearing, and check and lubricate the clutch separation bearing, seat and sleeve on time.
There are many reasons for the noise caused by electric forklifts. The staff should drive the forklift to the parking lot facility for special investigation and find the reason, so as to solve the doubt of the forklift noise from the source. The staff should pay attention to the operation and try to avoid it Noise generation.
